fbpx
Go Back

MAREN ProPAK 2R185 TWO RAM BALER
,New

REQUEST INFO

The Model ProPAK 2R185 is a fully automatic 2 RAM baler. The extra large feeder hopper can be adapted to gravity, pneumatic or belt conveyor automatic feed devices. After each bale is made, the chamber completely clears—so go ahead, switch materials on the fly—without making unwanted contaminated bales. A built-in shear eliminates the unnecessary extra step of “pre-conditioning” difficult materials. Using either Accent 470 or L.P. Pinnacle II wire-tie systems, the bale gets tied underneath and the short way: saving wire, increasing bale density and holding bales together better during transportation. This adds up to time and money savings!

 

PERFORMANCE DATA

Motor: 20hp ; (30hp Optional) TEFC Motor 460 Volt 3 Phase. Efficiency of hydraulic system allows for higher production rates with lower horsepower required

Hydraulic: 48 GPM 4400 psi rated, horsepower limited pressure compensated piston hydraulic pump w/ high pressure unloading valve, mounted below tank level to eliminate start up cavitation and extend pump life

Hydraulic System: Regenerative, 4,100 psi hydraulic pressure, 4500 psi max system pressure

Platen Force: 180,562 lbs.

Platen Pressure: 109 psi.

Cycle Time: SHORT : 24 seconds; FULL : 29 seconds

 

BALEWEIGHTS (TONS/HR.)*

BALE SIZE: 60″ Length x 40-48″ Width (*OS) x 30″ Height
OCC 1,500 lbs. SHORT STROKE – 1,600 lbs. : FULL STROKE (4.4)
MAGAZINES 2,000 lbs. (9)
NEWSPAPER 1,500 lbs. (8)
OFFICE PAPER 1,600 lbs. (8)
ALUMINUM CANS 700 lbs. (2.9)
TIN CANS 1,250 lbs. (5.5)
HDPE 1,125 lbs. (3.4)
PET 1,000 lbs. (2.5)
(percentage of caps on bottles will vary bale weights)

* Bale weights are approximate and may differ with moisture content, material density, etc.

 

REQUEST INFO